To set up the RECORDING LAMP, you only need a few components and a straightforward wiring process. Here's how to do it:
Components Needed:
- Stereo cable
- Latching switch (if not using GPO output)
- Barrier strip
- Power adapter
- Wall mounting hardware (if applicable)
Wiring Process:
- Stereo Cable: Connect one end of the stereo cable to the latching switch or GPO output of your equipment. If using a latching switch, ensure it's wired properly for on/off control.
- Barrier Strip: Inside the RECORDING LAMP unit, locate the barrier strip. Wire the other end of the stereo cable to the appropriate terminals on the barrier strip. This will provide the signal for the ON-AIR LAMP to activate.
- Power Adapter: Connect the power adapter to the RECORDING LAMP. Wire it directly to the barrier strip, ensuring proper polarity and voltage.
- Mounting: If you're mounting the RECORDING LAMP on a wall, use the cable entry hole and key slot holes on the backside for secure installation. Ensure it's positioned in a visible and accessible location.
Testing:
- Once everything is wired and mounted, test the RECORDING LAMP to ensure it functions as expected. Activate the latching switch or trigger the GPO output on your equipment to see if the lamp illuminates.
- If the lamp doesn't light up, double-check your wiring connections and ensure that power is reaching the unit.
By following these steps, you can easily set up the RECORDING LAMP for use in your studio or broadcasting setup. Ensure all connections are secure and test the functionality before regular use.